FMC Technologies Proline Promass 83 E - Function Description

Issue/Rev. 0.2 (12/12)
Page 182 • MN0M023
11 Block SUPERVISION Device Functions Proline Promass 83
REMOVE
SW-OPTION
(8006)
! Note!
This function is only available if:
• The F-CHIP software options were saved beforehand
• The F-CHIP is not located on the I/O board of the measuring device
Deletes all F-CHIP software options, such as batching, density functions, etc.
Options:
0 = NO
1 = YES
Factory setting: NO
" Caution!
If process variables which are only available via the F-CHIP software options are assigned
to the local display or the outputs, these have to be reconfigured. If reconfiguration does
not take place, the local display and the totalizer are set to the factory setting and the
outputs are set to OFF.
PERMANENT STRORAGE
(8007)
This function indicates whether permanent storage of all parameters in the EEPROM has
been switched on or off.
Display:
“OFF” or “ON”
Factory setting:
ON
Function description
SUPERVISION o SYSTEM o CONFIGURATION