FMC Technologies Proline Promass 83 E - Function Group DENSITY COEFFICIENT

Issue/Rev. 0.2 (12/12) MN0M023 • Page 137
Device Functions Proline Promass 83 9 Block BASIC FUNCTION
9.4.3 Function group DENSITY COEFFICIENT
BASIC FUNCTION G

HART GAA

PROCESS PARAMETER GIA

SYSTEM PARAMETER GLA

SENSOR DATA GNA

CONFIGURATION 680

FLOW COEFF. 684

DENSITY COEFFICIENT 685
Function description
BASIC FUNCTION o SENSOR DATA o DENSITY COEFFICIENT
All density coefficients are set at the factory. All the sensor's parameter settings are saved on the S-DAT memory chip.
Contact the E+H service organization if you have any questions about these functions.
DENSITY COEFFICIENT
C 0
(6850)
This function shows the actual density coefficient C 0.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C 1
(6851)
This function shows the actual density coefficient C 1.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C 2
(6852)
This function shows the actual density coefficient C 2.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C 3
(6853)
This function shows the actual density coefficient C 3.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C 4
(6854)
This function shows the actual density coefficient C 4.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C 5
(6855)
This function shows the actual density coefficient C 5.
" Caution!
A density adjustment can alter the calibration value of this coefficient.