FMC Technologies Proline Promass 83 E - Function Description

Issue/Rev. 0.2 (12/12)
Page 92 • MN0M023
7 Block OUTPUTS Device Functions Proline Promass 83
Function description
OUTPUTS o PULSE/FREQUENCY OUTPUT (1...2) o CONFIGURATION (STATUS)
ASSIGN STATUS
(4241)
! Note!
This function is not available unless the STATUS setting was selected in the OPERATION
MODE function (4200).
Use this function to assign a switching function to the status output.
Options:
OFF
ON (operation)
FAULT MESSAGE
NOTICE MESSAGE
FAULT MESSAGE or NOTICE MESSAGE
EMPTY PIPE DETECTION (only with active function)
FLOW DIRECTION
MASS FLOW LIMIT VALUE
VOLUME FLOW LIMIT VALUE
CORRECTED VOLUME FLOW LIMIT VALUE
DENSITY LIMIT VALUE
REFERENCE DENSITY LIMIT VALUE
TEMPERATURE LIMIT VALUE
TOTALIZER 1 LIMIT VALUE
TOTALIZER 2 LIMIT VALUE
TOTALIZER 3 LIMIT VALUE
Advanced options with optional software package BATCHING:
BATCH RUNNING
> BATCH TIME
>< BATCH QUANTITIES (< min. / > max. batching quantity)
PROGRESS NOTE (batching end approaching)
! Note!
The only options available are the monitoring functions (7240 to 7243) which have a
value not equal to zero (max. 3).
Advanced options with optional software package CONCENTRATION:
LIMIT TARGET MASS FLOW
LIMIT TARGET % MASS PROPORTION FLOW
LIMIT TARGET VOLUME FLOW
LIMIT TARGET % VOLUME PROPORTION FLOW
LIMIT TARGET CORRECTED VOLUME FLOW
LIMIT CARRIER MASS FLOW
LIMIT CARRIER % MASS PROPORTION FLOW
LIMIT CARRIER VOLUME FLOW
LIMIT CARRIER % VOLUME PROPORTION FLOW
LIMIT CARRIER CORRECTED VOLUME FLOW
LIMIT % BLACK LIQUOR
LIMIT °BAUME > 1
LIMIT °BAUME < 1
LIMIT °API
LIMIT °PLATO
LIMIT °BALLING
LIMIT °BRIX
LIMIT OTHERS (_ _ _ _ flexible concentration)
Advanced options with optional software package ADVANCED DIAGNOSIS:
LIMIT MASS FLOW DEVIATION
LIMIT DENSITY DEVIATION
LIMIT REFERENCE DENSITY DEVIATION
LIMIT TEMPERATURE DEVIATION
LIMIT TUBE DAMPING DEVIATION
LIMIT ELECTRODYNAMIC SENSOR DEVIATION
LIMIT OPERATING FREQUENCY DEVIATION
LIMIT TUBE DAMPING DEVIATION
(continued on next page)