Fortinet FortiVoice - Configuring LDAP Profiles

Fortinet Technologies Inc. Page 122 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
3. Click Create.
Configuring LDAP profiles
The LDAP submenu lets you configure LDAP profiles which can query LDAP servers for
authentication.
Before using an LDAP profile, verify each LDAP query and connectivity with your LDAP server.
When LDAP queries do not match with the server’s schema and/or contents, unintended phone
call processing behaviors can result.
Digit map The FortiVoice unit uses digit map syntax definition to define
the FortiFone dialing behavior. A phone needs to know when
number entering is complete and therefore to initiate the call.
You can enter the syntax or use the default syntax x.T|x+#
where:
• x.T means you can dial any number and the call is
initiated after the digit map pause timeout is reached.
• | is a choice operator that matches the expression before
or after the operator. For example, abc|def matches
"abc" or "def".
• x+# means you can enter any number and then press the
# key to initiate the call.
For more information about digit map syntax definitions, see
Section 2.1.5 of RFC 3435.
Set Programmable
Phone Key
Allows you to program the phone keys for FortiFone-260i to
560i. For FortiFones with expansion modules, you can select
the module to program the keys.
After completing programing the keys, you can click
Download printable label to save and print out the
configuration and label it on the phone.
Note that keys 1 and 2 are reserved and cannot be
programmed.
If you select One key dial or User defined function for a key,
you need to enter the information in the Resource field based
on your phone configuration. For example, if you select User
defined for key 3 and you want to map this key to your
voicemail code such as *78, enter *78 in the Resource field.
Selecting Centralized phonebook allows you to browse the
phone book from a FortiFone. You can also search on
FortiFones by name or number. Please note that this feature
works on top of HTTP protocol which is disabled by default in
system interface settings. If you want to use this feature,
enable HTTP under System > Network > Network.
Manual Configuration If you select Manual configuration mode, edit the phone
configuration file.