Fortinet Technologies Inc. Page 61 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
You must maintain the physical link between the heartbeat and synchronization network
interfaces. These connections enable a group member to detect the responsiveness of the
other member, and to synchronize data. If they are interrupted, normal operation will be
interrupted and a failover will occur. For more information on heartbeat and synchronization, see
“About the heartbeat and synchronization” on page 55.
You can directly connect the heartbeat network interfaces of the two FortiVoice units using a
crossover Ethernet cable.
To configure HA options
1. Go to System > High Availability > Configuration.
Figure 22: Active-passive HA (primary unit)
2. Configure the following sections, as applicable:
• “Configuring the primary HA options” on page 61
• “Configuring the advanced options” on page 62
• “Configuring interface monitoring” on page 63
• “Configuring service-based failover” on page 66
3. Click Apply.
Configuring the primary HA options
Go to System > High Availability > Configuration and click the arrow to expand the HA
Configuration section, if needed.
To Next Page
Loading...
