Fortinet FortiVoice - Adding Prompt Languages

Fortinet Technologies Inc. Page 110 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
2. Click Apply.
Adding prompt languages
The prompt language affects all of the FortiVoice unit’s voice prompts, such as auto attendant
and voicemail. Prompt languages are used when configuring the PBX settings. For more
information, see “Setting PBX location and contact information” on page 98.
However, if you change the sound file for an individual component, such as auto attendant, to
use a different language, it will override the default prompt language for this component.
The default prompt language is English.
For information on generating a prompt language file, see “Recording in FortiVoice audio
format” on page 111.
Standard (apply to
all server settings)
Select to configure the server settings for the supported phones.
The same settings apply to the SIP server, TFTP server, and NTP
server.
• Use IP address of interface: Select the interface for the server.
The SIP phones connect to this server to register and receive
the PBX setup information and use it as the NTP server. For
information on interface configuration, see “Configuring the
network interfaces” on page 40.
• Use static IP or host name: Enter the current public IP address
or public domain name of the server. The SIP phones connect
to this server to register and receive the PBX setup information
and use it as the NTP server.
Advanced If you use different servers for SIP, TFTP, and NTP, select to
configure the settings of each server for the supported phones.
• SIP server
• Use IP address of interface: Select the interface for the
server. The SIP phones connect to this server to register.
• Use static IP or host name: Enter the current public IP
address or public domain name of the server. The SIP
phones connect to this server to register.
• TFTP server
• Use IP address of interface: Select the interface for the
server. The SIP phones connect to this server to receive the
PBX setup information.
• Use static IP or host name: Enter the current public IP
address or public domain name of the server. The SIP
phones connect to this server to receive the PBX setup
information.
• NTP server
• Use IP address of interface: Select the interface for the
server. The SIP phones connect to this server to synchronize
time.
• Use static IP or host name: Enter the current public IP
address or public domain name of the server. The SIP
phones connect to this server to synchronize time.