Fortinet Technologies Inc. Page 108 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
3. Click Apply.
Configuring SIP phone auto-provisioning
Phone System > Advanced Settings > Auto Provisioning allows the FortiVoice unit to discover
the SIP phones on your network and send the configuration files to them.
With auto-provisioning configured, when a supported FortiFone is connected to the network
and powered on, it is automatically discovered and receives the configuration file from the
FortiVoice unit. The FortiFone will then reboot with the pushed-in configuration file and register
with the FortiVoice unit.
The FortiVoice unit can only auto provision the supported FortiFones.
To configure auto-provisioning settings
1. Go to Phone System > Advanced Settings > Auto Provisioning and configure the following:
RTP hold timeout Enter the amount of time in seconds that the extension will wait
on hold for RTP packets before hanging up the call. 0 means no
time limit. The default is 300.
TLS Client Setting If you have enabled TLS, configure the following:
• Server certificate verification: Select this option for the TLS
clients to confirm the validity of a server’s credentials with a
trusted root certification authority’s (CA’s) certificates. For
information on uploading a CA certificate, see “Managing
certificate authority certificates” on page 95.
• TLS protocol: Select the TLS protocol version.
Security By default, the FortiVoice unit screens out calls from callers who
have blocked their caller ID information. If you want to change
this default setting, select Allow anonymous call.
Advanced Setting Select Enable early media if you want the FortiVoice unit to relay
a ring tone to the caller of an incoming call before the
establishment of a call connection. A ring tone or a busy tone is
early media.
If you select this option, you also need to configure a specific
trunk to send the ring tone. See “Inband ringtone” on page 170.
To Next Page
Loading...
