Fortinet Technologies Inc. Page 78 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
Configuring SNMP queries and traps
Go to System > Configuration > SNMP to configure SNMP to monitor FortiVoice system events
and thresholds, or a high availability (HA) configuration for failover messages.
To monitor FortiVoice system information and receive FortiVoice traps, you must compile
Fortinet proprietary MIBs as well as Fortinet-supported standard MIBs into your SNMP
manager. RFC support includes support for most of RFC 2665 (Ethernet-like MIB) and most of
RFC 1213 (MIB II). For more information, see “FortiVoice MIBs” on page 82.
The FortiVoice SNMP implementation is read-only. SNMP v1, v2c, and v3 compliant SNMP
managers have read-only access to FortiVoice system information and can receive FortiVoice
traps.
The FortiVoice SNMP v3 implementation includes support for queries, traps, authentication, and
privacy. Before you can use its SNMP queries, you must enable SNMP access on the network
interfaces that SNMP managers will use to access the FortiVoice unit. For more information, see
“Editing network interfaces” on page 41.
This topic includes:
• Configuring an SNMP threshold
• Configuring email settings
• Configuring an SNMP v3 user
Configuring an SNMP threshold
Configure under what circumstances an event is triggered.
To set SNMP thresholds
1. Go System > Configuration > SNMP.
2. Configure the following:
To Next Page
Loading...
