Fortinet Technologies Inc. Page 75 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
3. Click Apply.
Configuring system options
The System > Configuration > Options tab lets you set the following global settings:
• system idle timeout
• password enforcement policy
• administration ports on the interfaces
To view and configure the system options
1. Go to System > Configuration > Options.
2. Configure the following:
Time zone Select the time zone in which the FortiVoice unit is located.
• Automatically adjust clock for daylight saving time changes:
Enable to adjust the FortiVoice system clock automatically when
your time zone changes to daylight savings time (DST) and back
to standard time.
Synchronize with
NTP Server
Select to use a network time protocol (NTP) server to automatically
set the system date and time, then configure Server and Sync
Interval.
• Server: Enter the IP address or domain name of an NTP server.
You can add a maximum of 10 NTP servers. The FortiVoice unit
uses the first NTP server based on the selection mechanism of
the NTP protocol.
Click the + sign to add more servers.
Click the - sign to remove servers. Note that you cannot remove
the last server.
To find the NTP servers that you can use, see http://www.ntp.org.
• Sync Interval: Enter how often, in minutes, the FortiVoice unit
should synchronize its time with the NTP server. For example,
entering 1440 causes the FortiVoice unit to synchronize its time
once a day.
Depending on your network traffic, it may take some time for the
FortiVoice unit to synchronize its time with the NTP server.
Set date Select this option to manually set the date and time of the FortiVoice
unit’s clock, then select the Year, Month, Day, Hour, Minute, and
Second fields before you click Apply.
Alternatively, configure Synchronize with NTP server.
To Next Page
Loading...
