Fortinet FortiVoice - Creating a SIP Trunk with Forticall Service

Fortinet Technologies Inc. Page 173 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
See also
• Creating a SIP trunk with FortiCall service
Creating a SIP trunk with FortiCall service
You can create one trunk with FortiCall and use it free for 30 days or 300 minutes, whichever
comes first. Note that the trial account only allows outbound calling and no international calling
is available.
If you sign up for the service during a trial use, the trial is closed and billing will start.
To create a SIP trunk with FortiCall service
1. Go to Trunks > VoIP > SIP.
2. Click FortiCall.
The Create SIP Trunk dialog box displays.
Figure 58: Creating a SIP trunk with FortiCall service
3. Note down the MAC Address and System ID for use if you decide to sign up for the service
later. See “To sign up for the FortiCall service” on page 174.
From number Enter the number from which you want to call the destination
number. The FortiVoice unit will connect this number with the
destination number for the test.
Test Click to start the dry run test and check the Test result.
Reset Click to remove the test result in order to start a new test.
Test Call Test the SIP trunk by making a real phone call.
Destination number Enter a destination number to call.
After call is
established
Select the FortiVoice action once it calls the destination
number:
• Play welcome message: The FortiVoice unit will play a
message to the destination number.
• Connect test call to number: In the Number field, enter the
number from which you want to call the destination
number. The FortiVoice unit will connect this number with
the destination number to test the trunk.
Test Click to start the test and check the Test result.
Reset Click to remove the test result in order to start a new test.