Fortinet FortiVoice - Configuring the T1;E1 Span

Fortinet Technologies Inc. Page 178 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
4. Click Create.
Configuring the T1/E1 span
You can configure the settings of the T1/E1 span, including full or fractional PRI (T1/E1), to
match the same settings of your PSTN service provider.
For more information, see “Hardware Property” on page 176.
To configure the T1/E1 span
1. On the PRI page, click a span name under Hardware Property.
2. Configure the following:
Fax Configure fax and phone signal automatic detection and fax
handling.
Automatic fax
detection
Select for the FortiVoice unit to detect incoming fax signal
on this trunk automatically.
eFax account Select the fax receiving account for the detected faxes.
Phone Number Click New to add the phone number provided by your PSTN
service provider. Your PSTN service provider will direct calls
from external callers directly to this number. You can add
multiple numbers.
For 2000E-T2, if a PRI trunk includes two spans, the configuration of the second span is much
simpler as the spans share many configurations.