Fortinet FortiVoice - Page 79

Fortinet Technologies Inc. Page 79 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
GUI field Description
SNMP agent
enable
Enable to activate the FortiVoice SNMP agent. This must be enabled
to accept queries from SNMP managers or send traps from the
FortiVoice unit.
Description Enter a descriptive name for the FortiVoice unit.
Location Enter the location of the FortiVoice unit.
Contact Enter administrator contact information.
SNMP Threshold To change a value in the four editable columns, select the value in any
row. It becomes editable. Change the value and click outside of the
field. A red triangle appears in the field’s corner and remains until you
click Apply.
Trap Type Displays the type of trap, such as CPU Usage.
Trigger You can enter either the percent of the resource in use or the number
of times the trigger level must be reached before it is triggered.
For example, using the default value, if the mailbox disk is 90% or
more full, it will trigger.
Threshold Sets the number of triggers that will result in an SNMP trap.
For example, if the CPU level exceeds the set trigger percentage once
before returning to a lower level, and the threshold is set to more than
one, an SNMP trap will not be generated until that minimum number
of triggers occurs during the sample period.
Sample
Period(s)
Sets the time period in seconds during which the FortiVoice unit
SNMP agent counts the number of triggers that occurred.
This value should not be less than the Sample Freq(s) value.
Sample
Freq(s)
Sets the interval in seconds between measurements of the trap
condition. You will not receive traps faster than this rate, depending
on the selected sample period.
This value should be less than the Sample Period(s) value.
Community Displays the list of SNMP communities (for SNMP v1 and v2c) added
to the FortiVoice configuration. For information on configuring a
community, see either “Configuring email settings” or “Configuring an
SNMP v3 user” on page 81.
Name Displays the name of the SNMP community. The SNMP Manager
must be configured with this name.
Status A green check mark icon indicates that the community is enabled.
Queries A green check mark icon indicates that queries are enabled.
Traps A green check mark icon indicates that traps are enabled.