Fortinet Technologies Inc. Page 80 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
Configuring an SNMP v1 and v2c community
An SNMP community is a grouping of equipment for SNMP-based network administration
purposes. You can add up to three SNMP communities so that SNMP managers can connect to
the FortiVoice unit to view system information and receive SNMP traps. You can configure each
community differently for SNMP traps and to monitor different events. You can add the IP
addresses of up to eight SNMP managers to each community.
To configure an SNMP community
1. Go to System > Configuration > SNMP.
2. Under Community, click New to add a community or select a community and click Edit.
The SNMP Community page appears.
3. Configure the following:
User Displays the list of SNMP v3 users added to the FortiVoice
configuration. For information on configuring a v3 user, see
“Configuring an SNMP v3 user” on page 81.
Name Displays the name of the SNMP v3 user. The SNMP Manager must be
configured with this name.
Status A green check mark icon indicates that the user is enabled.
Queries A green check mark icon indicates that queries are enabled.
Traps A green check mark icon indicates that traps are enabled.
Security Level The security level of the SNMP v3 user.
GUI field Description
Name Enter a name to identify the SNMP community. If you are editing an
existing community, you cannot change the name.
You can add up to 16 communities.
Enable Enable to send traps to and allow queries from the community’s SNMP
managers.
Community
Hosts
Lists SNMP managers that can use the settings in this SNMP
community to monitor the FortiVoice unit. Click Create to create a new
entry.
You can add up to 16 hosts.
IP Address Enter the IP address of an SNMP manager. By default, the IP address is
0.0.0.0, so that any SNMP manager can use this SNMP community.
Delete
(button)
Click to remove this SNMP manager.
Create
(button)
Click to add a new default entry to the Hosts list that you can edit as
needed.
To Next Page
Loading...
