Fortinet FortiVoice - Page 43

Fortinet Technologies Inc. Page 43 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
Type If you are creating a logical interface, select which type of interface
you want to create. For information about logical interface types, see
“About FortiVoice logical interfaces” on page 39.
• VLAN: If you want to create a VLAN subinterface, select the
interface for which you want to create the subinterface. Then
specify a VLAN ID. Valid VLAN ID numbers are from 1 to 4094,
while 0 is used for high priority frames, and 4095 is reserved.
• Redundant: If you want to create a redundant interface, select the
interface members from the available interfaces. Usually, you
need to include two or more interfaces as the redundant interface
members.
• Loopback: If you want to add a loopback interface, select the
Loopback type and the interface name will be automatically reset
to “loopback”. You can only add one loopback interface on the
FortiVoice unit.
Addressing Mode • Manual: Select to enter the IP address or IPv6 address and
netmask for the network interface in IP/Netmask or
IPv6/Netmask.
• DHCP: Select and click Update request to retrieve a dynamic IP
address using DHCP.