Fortinet Technologies Inc. Page 64 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
To configure interface monitoring
1. Go to System > High Availability > Configuration.
2. Select master or slave as the mode of operation.
3. Expand the Interface area, if required.
4. Click on the port/interface name to configure the interface. For details, see “Configuring the
network interfaces” on page 40.
5. Select a row in the table and click Edit to configure the following HA settings on the
interface.
The interface IP address must be different from, but on the same subnet as, the IP address of
the other heartbeat network interface of the other member in the HA group.
When configuring the other FortiVoice unit in the HA group, use this value as the remote peer IP.
GUI item Description
Port Displays the interface name you’re configuring.
Enable port
monitor
Enable to monitor a network interface for failure. If the port fails, the primary
unit will trigger a failover.
To Next Page
Loading...
