AlE
End arc length correction
For correcting the arc length at the end of welding
Setting range: -10 - -0.1 / auto / 0.0 - 10.0 (of welding voltage)
Factory setting: 0
- .... shorter arc length
0 ... neutral arc length
+ ... longer arc length
auto:
the value set in the welding parameters is taken over
t-E
Final current time
For setting the length of time for which the final current is to be active
Setting range: off / 0.1 - 10.0 s
Factory setting: off
SFI
To activate/deactivate the SFI function (Spatter-Free Ignition of the arc)
Setting range: off / on
Factory setting: off
SFI-HS
SFI HotStart
For setting a HotStart time in conjunction with SFI ignition
During SFI ignition, a spray arc phase occurs within the set HotStart time. This
increases the heat input irrespective of the mode, thus ensuring deeper penetra-
tion right from the very start of welding.
Setting range: off / 0.01 - 2.00 s
Factory setting: off
W-r
Wire retract
For setting the wire withdrawal value (= composite value based on backward
movement of wire and a time).
The wire withdrawal depends on the features of the welding torch.
Setting range: 0.0 - 10.0
Factory setting: 0.0
IgC
Ignition current (manual mode)
For setting the ignition current for MIG/MAG standard manual welding
Setting range: 100 - 450 A
Factory setting: 450
W-r (man.)
Wire retract (manual mode)
For setting the wire withdrawal value (= composite value based on backward
movement of wire and a time) for MIG/MAG standard manual welding.
The wire withdrawal depends on the features of the welding torch.
Setting range: 0.0 - 10.0
Factory setting: 0.0
109
EN
To Next Page
Loading...
