Fronius TPS/i COMPACT - Displaying Replaced Characteristics; Setting F1 and F2 Special Function Parameters Via the Setup Menu; Setting the Favourites Button Via the Setup Menu

Displaying re-
placed charac-
teristics
1
Select setup menu / Settings / View / DRSL
DRSL = Display replaced synergic lines
2
Press the right adjusting dial
3
Select "on" by turning the right adjusting dial
4
Press the right adjusting dial to activate the function
5
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
Setting F1 and
F2 special func-
tion parameters
via the Setup
menu
1
Select Setup menu / Settings / View / F1/F2 Param.
2
Press the right adjusting dial
The parameters currently stored under F1 and F2 are displayed.
If no parameters are stored, the first possible parameter is displayed.
3
Select the desired parameter by turning the right adjusting dial
4
Press the right adjusting dial
5
Turn the right adjusting dial to determine under which special function the
parameter should be stored:
- ... the parameter is not assigned to a special function/a stored parameter is
deleted
F1 ... parameter is stored under special function F1
F2 ... parameter is stored under special function F2
6
Press the right adjusting dial to confirm the selection
7
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
Setting the Fa-
vourites button
via the Setup
menu
1
Select Setup menu / Settings / View / Favourite
2
Press the right adjusting dial
The list of parent folders and parameters is displayed.
If a parameter or a folder is currently stored under the Favourites button, this is
indicated with at the end of the display.
3
Select the desired parameter or folder by turning the right adjusting dial
4
Press the right adjusting dial
5
Turn the right adjusting dial to determine whether the parameter or folder
should be stored under the Favourites button:
- ... parameter or folder is not stored
... parameter or folder is stored
6
Press the right adjusting dial to confirm the selection
The stored parameter or folder is indicated with at the end of the display.
7
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
129
EN