Update
Update The power source firmware can be updated in the "Update" entry.
The current version of the firmware on your power source is displayed.
To update the power source firmware:
The update file can be downloaded via the following link, for example:
https://tps-i.com/index.php/firmware
1
Organise and save the update file
2
Click on "Search update file" to start the update process
3
Select update file
Click on "Update"
Once the update has been successfully completed, the power source may need
to be restarted.
When an update has been completed successfully, a confirmation to this effect is
displayed.
Searching for an
update file (per-
forming the up-
date)
1
After clicking on "Search update file", select the desired firmware (*.ffw)
2
Click on "Open"
The selected update file is displayed on the power source SmartManager un-
der "Update".
3
Click on "Update"
A progress bar is displayed above the update process.
When this reaches 100%, you will be prompted to restart the power source.
SmartManager is not available during the restart.
After the restart, SmartManager may not be available any more.
If you select "No", the new software functions are activated when you next switch
the device on/off.
4
To restart the power source, click on "Yes"
The power source restarts; the display goes black for a short time.
The Fronius logo is shown on the power source display during the restart.
Once the update has been completed successfully, confirmation and the cur-
rent firmware version are displayed.
Finally, log back on to SmartManager.
145
EN
To Next Page
Loading...
