Retrieving
device informa-
tion
1
Select Setup menu / Settings / System / Information
2
Press the right adjusting dial
The first item of available information is displayed.
3
Select the desired information by turning the right adjusting dial
Serial number
Image version
IP address
MAC address
4
Press the right adjusting dial to display the information
5
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
Setting the spe-
cial display for
JobMaster
1
Select Setup menu / Settings / System / iJob
2
Press the right adjusting dial
3
Activate or deactivate the function by turning the right adjusting dial:
off ... the special display for JobMaster is deactivated
on ... the special display for JobMaster is activated
4
Press the right adjusting dial
5
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
The following can now be set and carried out on the JobMaster welding torch:
-
Mode
-
SynchroPulse
-
Gas test
Setting the
mode for spot
welding
1
Select Setup menu / Settings / System / SPm
2
Press the adjusting dial
3
Turn the adjusting dial and select the desired mode for spot welding
2-step = spot welding in 2-step mode:
The spot welding process runs for as long as the torch trigger is kept pressed
and ends no later than at the expiry of the spot welding time.
Releasing the torch trigger stops the spot welding process before the spot
welding time expires
4-step = spot welding in 4-step mode:
The spot welding process starts once the torch trigger is pressed and ends no
later than at the expiry of the spot welding time.
Press the torch trigger again to stop the spot welding process before the spot
welding time expires.
4
Press the right adjusting dial
5
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
More information on spot welding:
-
Page 86 (spot welding in general)
-
Page 115 (spot welding time)
132
To Next Page
Loading...
