Fronius TPS/i COMPACT - Welding Parameters for MIG;MAG Standard Manual Welding; Explanation of Footnotes

Welding para-
meters for
MIG/MAG
standard manual
welding
The following welding parameters can be set and displayed for MIG/MAG stand-
ard manual welding:
using the left adjusting dial:
Wire speed
1)
for setting a harder, more stable arc
Setting range: 0.5 - 25 m/min
2)
/ 20 - 980 ipm.
2)
Special function
any parameter can be assigned to this (see page 51)
The function can be selected if a parameter has been saved.
using the right adjusting dial:
Welding voltage
1)
in V
Setting range: depends on the welding process and welding program selected
Pulse/dynamic correction
for influencing the short-circuiting dynamic at the instant of droplet transfer
Setting range: 0 - 10
Factory setting: 0
0 ... harder and more stable arc
10 ... soft and low-spatter arc
Special function
any parameter can be assigned to this (see page 51)
The function can be selected if a parameter has been saved.
Explanation of
footnotes
1) Synergic parameter
When a synergic parameter is changed, the synergic function automatic-
93
EN