Fronius TPS/i COMPACT - Setting the Interior Lighting; Restoring the Factory Settings; Resetting the Password for the Power Source Website

Error output if coolant temperature > 70 °C
(measured during coolant return)
I-t
Arc time in h
DC-t
Total power source operating hours in h
Gcon
Total gas consumption in l
Setting the in-
terior lighting
1
Select Setup menu / Settings / System / CLS
2
Press the right adjusting dial
3
Select the desired duration by turning the right adjusting dial:
off ... interior lighting switched off
1 - 60 ... interior lighting is switched on for the duration entered
on ... interior lighting is switched on permanently
4
Press the right adjusting dial
5
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
Restoring the
factory settings
1
Select Setup menu / Settings / System / FAC
2
Press the right adjusting dial
3
Turn the right adjusting dial to select "Yes", thereby restoring the power
source to the factory settings
4
Press the right adjusting dial
The process parameters and machine default values are immediately reset to the
factory settings without any further warning.
5
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
Resetting the
password for the
power source
website
1
Select Setup menu / Settings / System / Web-PWreset
2
Press the right adjusting dial
3
Turn the right adjusting dial to select "Yes", thereby resetting the password
for the power source:
User name = admin
Password = admin
4
Press the right adjusting dial
The password is immediately reset to the factory settings without any further
warning.
5
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
131
EN