Settings
General
NOTE!
As a result of firmware updates, you may find that there are functions available
on your device that are not described in these Operating Instructions or vice
versa.
Certain illustrations may also differ slightly from the actual controls on your
device, but these controls function in exactly the same way.
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this device
and all system components.
Overview The settings contain the following options:
Under "View"
-
Units
-
Standards
-
Hold mode
-
UIBS - display brightness
-
DRSL - display replaced characteristics
-
F1/F2 - setting F1 and F2 special function parameters
-
Setting the parameters for the Favourites button
-
System data
Under "System"
-
CLS - Interior lighting setup
-
FAC - Restore factory settings
-
Web-PW reset - Reset the password for the power source website
-
Information
-
iJob - Jobmaster special display
-
Spm - Spot welding operating mode
Setting the units
1
Select Setup menu / Settings / View / Unit
2
Press the right adjusting dial
The first of the available units is displayed.
3
Select the desired unit by turning the right adjusting dial:
-
metric (mm, kg, etc.)
-
imperial (in., lbs., etc.)
4
Press the right adjusting dial to apply the units
5
To exit the Setup menu, press the "Welding process" and "Mode" buttons at
the same time
127
EN
To Next Page
Loading...
