Fronius TPS/i COMPACT - Welding Parameters for MIG;MAG Standard Synergic Welding, LSC Welding and CMT

using the right adjusting dial:
Arc length correction
for correcting the arc length;
Setting range: -10 - +10
Factory setting: 0
- .... shorter arc length
0 ... neutral arc length
+ ... longer arc length
Welding voltage
1)
in V
Setting range: depends on the welding process and welding program selected
Before the start of welding, the device automatically displays a standard value
based on the programmed parameters. The actual value is displayed during weld-
ing.
Pulse/dynamic correction
for correcting the pulsing energy of a pulsed arc
Setting range: -10 - +10
Factory setting: 0
- ... lower droplet detachment force
0 ... neutral droplet detachment force
+ ... increased droplet detachment force
Special function
any parameter can be assigned to this (see page 51)
The function can be selected if a parameter has been saved.
Welding para-
meters for
MIG/MAG
standard syner-
gic welding, LSC
welding and CMT
welding
The following welding parameters for MIG/MAG standard synergic welding, LSC
welding and CMT welding can be set and displayed:
using the left adjusting dial:
90