Fdi
Feeder inching speed
in m/min (ipm)
For setting the wire speed at which the wire electrode is threaded into the torch
hosepack
Setting range:
min. - max. (depending on the wire speed)
Factory setting: 10.0 m/min
ito
Ignition time-out
Length of wire that is fed before the safety cut-out trips
Setting range: off / 5 - 100 mm (0.2 - 3.94 in.)
Factory setting: off
The ignition time-out process parameter is a safety function. The length of wire
that is fed before the safety cut-out trips may differ from the pre-set wire length,
particularly when the wire is being fed at fast wire speeds.
How it works:
Once the torch trigger is pressed, gas pre -flow begins immediately. Wirefeeding
then begins, followed by ignition. If no current starts flowing before the specified
length of wire has been fed, the power source cuts out automatically.
To try again, press the torch trigger again.
GSL
Lower gas flow rate limit
Setting range: 0.5 - 30.0 l/min
Factory setting: 7.0 l/min
GSt
Maximum duration of gas flow deviation
Setting range: off; 0.1 - 10.0 s
Factory setting: 2.0 s
GSF
Gas factor sensor
Dependent on the shielding gas used
(only in conjunction with the OPT/i gas controller option)
Setting range: auto, 0.90 - 20.0
Factory setting: auto
(the correction factor is automatically set for standard gases from the Fronius
welding database)
FFR
Reaction in case of deviation of the wire speed force
Setting range: Ignore / Warning / Error
Factory setting: Ignore
FFu
Upper wire feed speed force
Setting range: 0 - 999 N
Factory setting: 0 N
FFt
Max. duration of wire speed deviation
116
To Next Page
Loading...
