Fronius TPS/i COMPACT - Page 120

1
2
3
4 5
1
Welding
2
At the end of the welding action, briefly raise the welding torch
The arc length is increased significantly.
3
Lower the welding torch
-
The arc length is reduced significantly
-
The TIG Comfort Stop function is triggered
4
Keep the welding torch at the same height
-
The welding current is continuously decreased (downslope).
-
The arc goes out.
IMPORTANT! The downslope is pre-set and cannot be adjusted.
5
Raise the welding torch from the workpiece
120