Fronius TPS/i COMPACT - Page 5

Setting the welding process and operating mode 81
Retrieving the currently set filler metal 82
Selecting the filler metal 82
Setting the welding parameters 84
Set the shielding gas flow rate 85
MIG/MAG or CMT welding 85
Spot and stitch welding 86
Spot welding 86
Stitch welding 87
MIG/MAG and CMT welding parameters 89
Welding parameters for MIG/MAG pulse synergic welding and PMC welding 89
Welding parameters for MIG/MAG standard synergic welding, LSC welding and CMT
welding
90
Welding parameters for MIG/MAG standard manual welding 93
Explanation of footnotes 93
EasyJob mode 95
General 95
EasyJob mode 95
TIG welding 96
Safety 96
Preparations 96
TIG welding 96
Igniting the arc 98
Finishing welding 98
MMA welding 99
Safety 99
Preparations 99
MMA welding 99
Welding parameters for manual metal arc welding 101
Setup settings 103
Setup menu - overview 105
Entering/exiting the Setup menu 105
Setup menu - overview 106
Process parameters 108
Process parameters for start of welding/end of welding 108
Process parameters for Gas-Setup 110
Process parameters for process control 110
Penetration stabilizer 110
Arc length stabilizer 112
Combination of penetration stabilizer and arc length stabilizer 114
Process parameters for spot welding 115
Process parameters for stitch welding 115
Process parameters for monitoring and components 115
Process parameters for electrode setup 117
Process parameters for TIG setup 119
Process parameters for SynchroPulse 121
Process parameters for Process Mix 123
R/L alignment 125
Settings 127
General 127
Overview 127
Setting the units 127
Setting the standards 128
Setting hold mode 128
Setting the display brightness 128
Displaying replaced characteristics 129
Setting F1 and F2 special function parameters via the Setup menu 129
Setting the Favourites button via the Setup menu 129
Retrieving system data 130
Setting the interior lighting 131
5
EN