Copyright © 2016 Frontier Communications. All Rights Reserved.
8.4/ ROUTING
You can configure the following settings:
• IPv6 – enables IPv6 support.
• Routing – manages the routing and IP address distribution rules.
• IP Address Distribution - adds computers configured as DHCP clients
to the network 8.4a/ IPv6Use the IPv6 feature settings to
enable, disable, or configure an IPv6 Internet connection and
IPv6 LAN settings.
1. To configure your network to use the IPv6 Internet connection type.
Select IPv6 from the Advanced page to display the IPv6 service options:
2. Select Enable under the Enable IPv6 Support option. (Once IPv6 is
enabled the default setting will be IPv6 WAN as DHCPv6 and IPv6 LAN
as Stateless).
3. Select the appropriate IPv6 connection method from the drop-down
list, as shown below to specify the method to be used to obtain
your WAN IPv6 Address.
4. Click Apply to have changes take effect.
Note: The Internet IPv6 service is required for this feature to work over the
Internet.
5. To disable the IPv6 service click on the “Disable” option as shown
below and click Apply to have changes take effect.
Once configured using valid IPv6 WAN and LAN configurations you
should not see any errors when you click on the “Apply” button and the
Main page will reflect the router’s new IPv6 address as shown below.
To Next Page
Loading...
