Copyright © 2016 Frontier Communications. All Rights Reserved.
CONNECTING A WI-FI DEVICE USING A PASSWORD
1. Verify each device that you are connecting wirelessly (using Wi-Fi) has
a built-in wireless or external wireless adapter.
2. Open the device’s wireless settings application.
3. Select your Gateway’s wireless network name (SSID) from the device’s
list of discovered wireless networks.
4. When prompted, enter your Gateway’s wireless password (WPA2
key) into the device’s wireless settings. Your Gateway’s default
wireless network name and wireless password are located are on
the sticker on the side of your Gateway.
5. Verify the changes were implemented by using the device’s web
browser to access a site on the Internet.
6. Repeat these steps for every device that you are wirelessly connecting
to your Gateway.
COAXIAL
1. Verify all coax devices are turned off.
2. Disconnect any adapter currently connected to the coaxial wall jack
in the room where your Gateway is located.
3. Connect one end of the coaxial cable to the coaxial wall jack and the
other end to the Coax port on your network device.
4. Power up the network device.
To Next Page
Loading...
