Copyright © 2016 Frontier Communications. All Rights Reserved.
below:
2. Specify the Stateful (DHCPv6) settings to be used to assign LAN IPv6
addresses by entering the following details:
• IPv6 LAN Configuration (select Stateful from the drop- down list) as
• LAN Prefix
• LAN IPv6 Link Local Address (automatically populated)
• LAN IPv6 Address Range (start and end)
• Router Advertisement Lifetime (minutes between 0-150)
• IPv6 Address Lifetime (minutes between 3-150)
• Interfaces - check one or more of the box(s) to apply IPv6 LAN settings
to the selected interfaces:
– Ethernet/Coax IPv6 Enabled
– Wireless Access Point 1 IPv6 Enabled
– Wireless Access Point 2 IPv6 Enabled
3. After entering all appropriate IPv6 settings click Apply to have
changes take effect.
DHCPv6 WAN WITH LAN IPv6 STATELESS SETTINGS:
1. To configure IPv6 LAN Stateless mode with DHCPv6 WAN, select the
Stateless option on the IPv6 Configuration Control Page as shown
below:
To Next Page
Loading...
