Copyright © 2016 Frontier Communications. All Rights Reserved.
2. To allow only devices with specific MAC addresses, clickthe Wireless
MAC Authentication link. The Wireless MAC Authentication page
displays. For additional details, refer to the Wireless MAC
Authentication section.
3. To limit access based on the type of technology, click the 802.11
b/g/n/ac Mode link. The 802.11 b/g/n/ac Mode page displays. For
additional details, refer to the 802.11 b/g/n/ac Mode section.
4. To access other advanced wireless options, click the Other Advanced
Wireless Options link. The Other Advanced Wireless Options page
displays. For additional details, refer to the Other Advanced
Wireless Options section.
3.4/ WIRELESS MAC AUTHENTICATIONYou can allow or deny
access to your wireless network by specifying
devices with specific MAC addresses.
To set wireless MAC authentication:
1. On the Advanced Settings page, locate the Level 2 section and click
the Wireless MAC Authentication link. The Wireless MAC
Authentication page displays.
2. To enable access control, select the Enable Access List check box.
3. Select either:
• Accept all devices listed below – allows only the listed devices
to access the wireless network. Warning: This will block
wireless network access for all devices not in the list. Only
devices in the list will be able to connect to the wireless network.
To Next Page
Loading...
