Copyright © 2016 Frontier Communications. All Rights Reserved.
• Reset Button - allows you to reset your Gateway to the factory default
settings. To reset the Gateway, press and hold the Reset button
for at least three seconds.
• Ethernet LAN - connects devices to your Gateway using Ethernet
cables to join the local area network (LAN). The four Ethernet LAN
ports are 10/100/1000 Mbps auto-sensing and can be used with
either straight-through or crossover Ethernet cables.
• HAN Expansion Port - provides for future hardware upgrades to add
support for Home Area Networking capabilities.
• Ethernet WAN - connects your Gateway to the Internet using an
Ethernet cable.
• Coax WAN and LAN - connects your Gateway to the Internet and/or
to other MoCA devices using a coaxial cable. Warning: The WAN
Coax Port is intended for connection to FiOS only. It must not be
connected to any exterior or interior coaxial wires not designated for
FiOS.
• Power - connects your Gateway to an electrical wall outlet using the
supplied power adapter. Warning: The included power adapter is
for home use only, supporting voltages from 100-240Vac. Do not use in
environments with greater than 240Vac.
If you are replacing an existing wall mounted router, you do not need to
remove the mounting screws from the wall. The existing mounting
screws will fit the new bracket.
To mount your Gateway to a wall:
1. Remove the foot by turning the Gateway upside down and removing
the single screw that holds the foot to the Gateway.
To Next Page
Loading...
