Copyright © 2016 Frontier Communications. All Rights Reserved.
2. Specify the Stateless settings to be used to assign LAN IPv6 addresses
by entering the following details:
• IPv6 LAN Configuration (select Stateless from the drop- down
list) as shown in drop-down list and page below:
• LAN Prefix (automatically populated)
• LAN IPv6 Link Local Address (automatically populated)
• Router Advertisement Lifetime (minutes between 0-150)
• Interfaces - check one or more of the box(s) to apply IPv6 LAN
settings to the selected interfaces:
– Ethernet/Coax IPv6 Enabled
– Wireless Access Point 1 IPv6 Enabled
– Wireless Access Point 2 IPv6 Enabled
3. After entering all appropriate IPv6 settings click Apply to have
changes take effect.
LAN IPv6 CONFIGURATION WITHOUT AN IPv6 WAN CONNECTION:
1. To configure IPv6 to use either the IPv6 LAN Statefulor Stateless
mode without using an IPv6 Internet WAN connection, select the
None option on the IPv6 Configuration Control Page as shown
below:
2. After entering all appropriate IPv6 settings click Apply to have
changes take effect.
LAN IPv6 STATEFUL (DHCPv6) WITH NO WAN SETTINGS:
To Next Page
Loading...
Need help?
General
