Copyright © 2016 Frontier Communications. All Rights Reserved.
1. In the Broadband Connection (Ethernet/Coax) Properties page, click
Settings. The configuration page displays.
2. Configure the following settings, as needed.
GENERAL
Verify the following information:
• Status - displays the connection status of the network.
• Network – displays the type of network connection.
• Connection Type - displays the type of connection.
• Physical Address - displays the physical address of the network card
used for the network.
– Automatic - sets the MTU (Maximum Transmission Unit at
1500)
– Automatic by DHCP - sets the MTU according to the DHCP
To Next Page
Loading...
