Copyright © 2016 Frontier Communications. All Rights Reserved.
Internet.
To configure static NAT:
1. Select Static NAT.
2. To create a static NAT, click Add. The Add NAT/NAPT Rule page
displays.
6.6/ STATIC NAT
STATIC NAT AND SECURITY LOG
3. Select a source address in the Specify Address field or enter an IP
address in the text box.
4. Enter the public IP address.
5. If using port forwarding, select the Enable Port Forwarding for Static
NAT check box.
6. Click Apply to save changes.
7. Repeat these steps to add additional static IP addresses.
6.7/ SECURITY LOG
You can view events that your firewall has blocked by accessingthe
security log. Your Gateway reports events, such as attempts to establish
inbound and outbound connections, attempts to authenticate at an
administrative interface, such as your Gateway GUI, firewall
configuration, and system start-up.
• Time - based on the date and time in your Gateway
To Next Page
Loading...
