Copyright © 2016 Frontier Communications. All Rights Reserved.
– Ethernet/Coax IPv6 Enabled
– Wireless Access Point 1 IPv6 Enabled
– Wireless Access Point 2 IPv6 Enabled
3. After entering all appropriate IPv6 settings click Apply to have
changes take effect.
DHCPv6 - WAN IPv6 ADDRESS CONNECTION
The IPv6 WAN DHCPv6 configurations are IPv6 settings that you enter
that will allow your IPv6 connection to be updated by the ISP as
needed.
1. To configure IPv6 WAN Stateful (DHCPv6) mode, select the Stateful
(DHCPv6) option on the IPv6 Configuration Control Page as shown
below:
2. Specify the DHCPv6 method to be used to obtain your WAN IPv6
Address by entering:
• IPv6 WAN Configuration (select DHCPv6 from the drop- down list) as
shown in drop-down list and page below:
3. Check to either ‘Obtain IPv6 DNS Server address automatically’, or to
‘Use the following IPv6 DNS Server addresses’
4. After entering all appropriate IPv6 settings click Apply to have
changes take effect.
DHCPv6 WAN WITH LAN IPv6 STATEFUL (DHCPv6) SETTINGS:
1. To configure IPv6 WAN Stateful (DHCPv6) mode, select the Stateful
(DHCPv6) option on the IPv6 Configuration Control Page as shown
To Next Page
Loading...
