Copyright © 2016 Frontier Communications. All Rights Reserved.
1. To configure IPv6 LAN Stateful mode with Static WAN, select the
Stateful (DHCPv6) option on the IPv6 Configuration Control Page
as shown below:
2. Specify the Stateful (DHCPv6) settings to be used to assign LAN IPv6
addresses by entering the following details:
• IPv6 WAN Address
• Prefix Length (A numeric value between 16 and 128)
• Default Gateway
• Primary DNS Server
• Secondary DNS Server
• IPv6 LAN Configuration (select Stateful from the drop- down list) as
shown in drop-down list and page below:
• LAN Prefix
• LAN IPv6 Link Local Address (automatically populated)
• LAN IPv6 Address Range (start and end)
• Router Advertisement Lifetime (minutes between 0-150)
• IPv6 Address Lifetime (minutes between 3-150)
• Interfaces - check one or more of the box(s) to apply IPv6 LAN settings
to the selected interfaces:
– Ethernet/Coax IPv6 Enabled
To Next Page
Loading...
