Copyright © 2016 Frontier Communications. All Rights Reserved.
You can edit the DHCP server settings for a device.
To edit the settings:
ROUTING
2. To enable the DHCP server, select DHCP Server in the IP Address
Distribution field. Once enabled, the DHCP server provides
automatic IP assignments (IP leases) based on the preset IP range
defined below.
3. To configure the DHCP server complete the following fields:
• Start IP Address – enter the first IP address that your Gateway
will automatically begin assigning IP addresses from. Since
your Gateway’s default IP address is 192.168.1.1, the default
start IP address should be 192.162.1.2.
• End IP Address – enter the last IP address that your Gateway will
automatically stop the IP address allocation. The maximum
end IP address range that can be entered is 192.168.1.254.
• WINS Server – determines the IP address associated with a
network device.
• Lease Time in Minutes – assigns the amount of time in minutes
that each device is assigned an IP address by the DHCP
server when it connects to the network. When the lease
expires, the server determines if the computer has
disconnected from the network. If it has, the server may
reassign this IP address to a newly- connected computer.
• Provide Host Name if Not Specified by Client – when activated,
To Next Page
Loading...
