10 Setups
300
Setups
10
Auto Clear
If a given time period elapses with no operation, the machine automatically returns to
the initial screen.
Set a period from 1 to 4 minutes, in intervals of 1 minute. In order not to set this, select
[No].
Note • Even when [No] is selected, when there is no operation for 1 minute on the screen waiting
for a job command after scanning, the machine cancels the waiting condition and starts
processing the job.
1 Select [Auto Clear] and select
[Change Settings].
2 Select [Off] or [On].
3 If you selected [On], set the time.
Auto Job Release
Set the time that elapses when, during a copy or scan, an error (paper feed, original
jam, copy jam, etc.) occurs, until the current job is cleared, enabling the next job. At this
point, jobs that can be continued are limited to those that only use parts of the machine
not affected by the error.
Set the value in the range 4 to 99 minutes, in 1 minute increments. In order not to set
this, select [No].
1 Select [Auto Job Release], and
select [Change Settings].
2 Select [Off] or [On].
3 If you selected [On], set the time.
To Next Page
Loading...
Need help?
General
