Print Mode Settings
345
Setups
10
Receiving Buffer - LPD Spool
îš„Off
Do not use spooling. While LPD print processing is being carried out for one client, data
cannot be received over the same interface from another client. Set a value for the
dedicated LPD receiving buffer memory capacity from 1024 to 2048 KB, in 32 KB
increments.
îš„Memory
Carry out spooling. The receiving buffer for spooling uses memory. When this
candidate value is selected, set the memory capacity of the receiving buffer for
spooling, from 0.50 MB to 32.00 MB, in 0.25 MB increments.
Note that print data exceeding the set memory capacity is not accepted. In such cases,
select [Hard Disk], or [Off].
îš„Hard Disk
Carry out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - NetWare
Set the NetWare receiving buffer.
Set a value from 64 to 1024 KB, in 32 KB increments.
Receiving Buffer - SMB Spool
îš„Off
Do not use spooling. While SMB print processing is being carried out for one client,
data cannot be received over the same interface from another client.
Set a value for the dedicated SMB receiving buffer memory capacity from 64 to 1024
KB, in 32 KB increments.
îš„Memory
Carry out spooling. The receiving buffer for spooling uses memory. When this
candidate value is selected, set the memory capacity of the receiving buffer for spooling
from 0.50 MB to 32.00 MB, in 0.25 MB increments.
Note that print data exceeding the set memory capacity is not accepted. In such cases,
select [Hard Disk], or [Off].
îš„Hard Disk
Carry out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - IPP Spool
îš„Off
Do not use spooling. While IPP print processing is being carried out for one client, data
cannot be received over the same interface from another client. Set a value for the
dedicated IPP receiving buffer memory capacity from 64 to 1024 KB, in 32 KB
increments.
îš„Hard Disk
Carry out spooling. The receiving buffer for spooling uses the hard disk.
To Next Page
Loading...
Need help?
General
