Copying Procedure
55
Copy
3
1 Remove any clips and staples
before loading the document.
2 Shift the document guide gently to
touch the document edges.
3 Adjust the movable document
guides to just touch the edge of the
document bunch.
Note • The <Confirmation> indicator
lights when the document is
loaded correctly.
When placing the document in the
Document Feeder, you can set
timing for lifting up the document
feeder tray.
For more information about settings, refer to "Document Feeder Tray Elevation" (P.323).
Document Glass
On the document glass, you can place a single sheet, or a book or other similar
document, up to 297 × 432 mm (A3, 11 × 17 inches).
On the document glass, only standard size documents can be detected automatically.
For non-standard size documents, enter a custom size in [Original Size].
For information about entering a custom size, refer to "Original Size (Specifying the Scan Size for the
Document)" (P.79).
Note • The standard document sizes that can be auto-detected depend on the [Paper Size
Settings] in the System Administration mode. For more information, refer to "Paper Size
Settings"(P.318).
1 Open the document cover.
Do not apply excessive force to hold thick document on the platen glass. It may break
the glass and cause injuries.
To Next Page
Loading...
Need help?
General
