16 Specifications
568
Specifications
16
Form Overlay 64 By selecting one of the registered form names (Nos.01 to 64), the form is
always superimposed on the printing.
[0] (Default): Off
[1 to 64] : No.1 to No.64
Important • Since this setting is for selecting the default setting, it is not reflected
when an extended command is sent.
• Once a form is selected, even if the form is deleted, the form name is
still displayed. Note that after performing form selection with the up
and down keys, it is not displayed. In this case, "No form" becomes
selected.
Stapling 66 Sets the position for stapling.
[0] (Default): Off
[1] : Upper left single
[2] : Top edge dual
[3] : Upper right single
[4] : Left edge dual
[5] : Right edge dual
[6] : Lower single
[7] : Bottom edge dual
[8] : Lower right single
Punching 69 Sets the position for punching.
[0] (Default): Off
[1] : Top
[2] : Bottom
[3] : Left
[4] : Right
Punch holes 70 Select the number of punch holes.
[0] (Default): 2
[1] : 3
[2] : 4
Binary data
specification text
72 Configure the specification text which inputs a command by hexadecimal
form.
[0] (Default) : OFF
[1] : &$%$
[2] : $?!#
Setting item
Item
number
Setting values
To Next Page
Loading...
Need help?
General
