HP-GL2 Emulation
585
Specifications
16
Scaling Mode 160 0 (Default): Paper Size
1: Active Coordinate Area
Determines how the document size and the paper size
are determined when Document Size (the item number
101) and/or Paper Size (102) is set to Auto (99).
[Paper Size]...Make the document size the minimum size
that combines the active coordinate area from the active
coordinate determining method and the active coordinate
obtained by the settings of Origin Position and Paper
Margin.
[Active Coordinate Area]...Make the document size the
area from which the paper margin is subtracted from the
active coordinate area obtained by the active coordinate
determining method.
Active Area
Determining Command
161 0 (Default): Auto
1: PS
2: IW
3: IP
4: Adapted
When auto-scaling is in use, this sets the method for
obtaining the active coordinate area.
[Auto]...Determines any of the methods listed below: PS,
IW, IP, or Adapted.
[PS]…Area specified by the first PS command is to be a
rectangular area.
[IW]...Area specified by the very last IW command is to
be a rectangular area.
[IP]...Area which combines all the IP Commands is to be
a rectangular area.
[Adapted]...The maximum/minimum coordinates within
the areas and coordinates plotted using the drawing
command, and the maximum size of characters and line
width specified in the page, are used to calculate the
rectangular area.
Paper Margin 162 0~99 (Default): 0): 0~99mm
Sets the paper margin when auto scaling is being used.
Image Enhancement 163 0: OFF
1 (Default): ON
Sets whether to artificially increase the resolution of an
image and smooth its edges.
Stapling 164 0 (Default): None
1: Top Left
2: Top Double
3: Top Right
4: Left Double
5: Right Double
6: Bottom Left
7: Bottom Double
8: Bottom Right
9: Center
Sets the stapling position.