Default Settings
169
Tools
9
Original Type
Sets the default value displayed for [Original Type]. This setting optimizes the copy
characteristics for the specified document type.
[Text] is set at the time of factory shipment.
îš„ Text
Set when copying documents with sharp black and white contrast, such as text documents.
îš„ Photo & Text
Set when copying documents containing both text and photos.
îš„ Photo
Set when copying photos.
Note • This item is disabled when [Color Mode] is set to [Black & White] and enabled when [Color Mode] is
set to [Color].
Lighten/Darken
Sets the default copy density value displayed in [Lighten/Darken].
You can select [Darken +2], [Darken +1], [Normal], [Lighten +1], [Lighten +2], or [Toner
Saver].
[Normal] sets the copy density at about the same as the document; [Darken +2] sets a
higher density than the document; [Lighten +2] sets a lower density.
[Toner Saver] sets the following values for each feature to conserve the toner usage.
[Lighten/Darken]: Lighten +2, [Sharpness]: Sharpen +2, and [Original Type]: Photo& Text.
[Normal] is set at the time of factory shipment.
Edge Erase
Sets the default value displayed for [Edge Erase]. Setting a value for this menu item erases
the black shadows created around the edges of the paper when copying with the document
cover open.
You can set values between 0 and 50 mm (in 1 mm increments).
[2 mm] is set at the time of factory shipment.
ID Card Copy
Sets the default advanced ID Card Copy settings displayed when the control panel’s <ID
Card Copy> button is pressed.
Original Size
Sets the default value displayed for [Original Size].
You can select values between 86 and 297 mm (in 1 mm increments).
[100 mm] is set at the time of factory shipment.
Original Type
Sets the default value displayed for [Original Type]. This setting optimizes the copy
characteristics for the specified document type.
[Text] is set at the time of factory shipment.
To Next Page
Loading...
Need help?
General
