14 Appendix
298
Appendix
14
îš„ Automatic Cancellation of Print Jobs
A job is canceled if a malfunction occurred in the machine or the selected tray that is not
installed.
îš„ 2 Sided Printing
When performing 2 Sided printing with the machine that the Duplex Output Unit is not
installed, it prints only one side.
In this case, the orientation of prints may not be the same as expected.
îš„ Memory Full Errors
z
A File System Full or similar error will appear during attempts to send print data at
volumes exceeding 30 MB per job using the LPD protocol and printing will be disabled. If
this occurs, change the protocol in the [Port Settings] of the printer driver to Port9100
(RAW DATA Socket), or break the job into different sections before printing.
z
If the machine stops due to an error caused by the machine running out of paper, the
cover on the machine being open, or some other issue, the last job will be canceled while
in progress if an attempt is made to send continuous print job data exceeding 30 MB
total, even with local printing via USB or printing using the Port9100 protocol. (Jobs for
files that are stored during printing will resume printing once the error has been resolved
and removed.) To restart printing for the last job that was canceled, first remove the write
error message displayed on the client computer side before attempting to execute the
print job again.
Notes and Restrictions on the Use of the Scan Feature
This section describes notes and restrictions to observe when using the Scan feature.
For the notes and restrictions on the scan driver, see the "Readme" information on the CD-ROM for the Driver CD Kit that
came with the machine.
îš„ Restriction on Scanning Capacity
The maximum scanning capacity for one page is 297 × 432 mm. For standard sizes, A3 or
11 × 17 inches.
To Next Page
Loading...
Need help?
General
