4 Loading Paper
94
Loading Paper
4
Changing the Paper Settings
This section describes how to change the paper type setting for a tray.
A paper type is preset for Trays 1 to 4. Normally, [Plain 1] is set for the trays. To maintain
the same print quality after changing paper in a different quality in the same tray, you need
to change the paper quality setting for the tray that matches new paper loaded.
For more information, refer to "Supported Paper Type" (P.85).
For information on the paper size setting for Tray 5, refer to "Tray 5" (P.175).
1 Press and hold the <Log In/Out> button for at
least 4 seconds.
2 Use the numeric keypad to enter the passcode,
and then press the <OK> button.
Note • The passcode is initially set to "11111"(five "1"
digits).
• The <Log In/Out> button lights up when the
machine is in System Administration mode.
3 Select [Tray Settings], and then press the <OK>
button.
4 Select the desired paper tray, and then press the
<OK> button.
5 Select [Paper Type], and then press the <OK>
button.
Note • If you select Tray 5 (bypass), [Paper Size] and
[Paper Type] are displayed. To change the
paper size, select [Paper Size].
6 Select the desired paper type, and then press the
<OK> button.
7 Press the control panel's <Log In/Out> button.
Note • The <Log In/Out> button light goes out when the machine has exited System Administration mode.
1
2
45
78
0
[ ]
System Admin. Passcode
Tray Settings
...
Device Information
...
Tools
Default Settings
...
Tray 2
...
Tray 3
...
Tray Settings
Tray 1
...
Tray 1
Paper Type
...
Plain1
Plain 2
Paper Type
Plain 1
Lightweight
To Next Page
Loading...
Need help?
General
