9 Tools
184
Tools
9
Wired Network
Used to make network environment settings.
Note • This function does not display unless the Network Kit is installed.
For information on how to display the [Wired Network] screen, refer to "System Settings Procedure" (P.162).
Ethernet
Used to set the Ethernet type to use.
Speed
You can select [Auto], [10BASE-T Half], [10BASE-T Full], [100BASE-TX Half], or [100BASE-TX
Full].
[Auto] is set at the time of factory shipment.
MAC Address
Displays the MAC Address. Not supported by the machine.
TCP/IP
Sets TCP/IP.
Note • This setting is activated after restarting the machine.
IP Mode
Sets the TCP/IP operation mode.
[IPv4] is set at the time of factory shipment.
îš„ Dual Stack
Select this setting when using the machine in an environment using both IPv4 and IPv6.
îš„ IPv4
Select this setting when using the machine in an IPv4 environment.
îš„ IPv6
Select this setting when using the machine in an IPv6 environment.
IPv4
Sets IPv4.
îš„ Get IP Address
Sets the method used to acquire the IP address, subnet mask, and gateway address.
z
DHCP
Automatically acquires the IP address, subnet mask, and gateway address from the DHCP
server.
z
BOOTP
Automatically acquires the IP address, subnet mask, and gateway address from the
BOOTP server.
To Next Page
Loading...
Need help?
General
