Fax Settings
191
Tools
9
Line Type
Sets the line type to use.
[PSTN] is set at the time of factory shipment.
PSTN
Set for fax transmissions on a standard phone line.
PBX
Set for fax transmissions on an internal private branch exchange within a corporation, or on
a public line.
Dial Type
Sets the dial type.
You can select [PB], [DP (10 PPS)], or [DP (20 PPS)].
Note • The default value varies by region. The default value is set when [Region] is set.
Call Interval
Sets the amount of time the machine waits between the end of transmission and the start
of the next.
You can set a value between 3 and 255 seconds (in 1 second increments).
Setting a high Call Interval value increases the total time needed for "broadcast" faxes (sent
to multiple recipients at once), but the machine can receive faxes during the waiting periods.
Note • The default value varies by region. The default value is set when [Region] is set.
Redial Attempts
Sets the number of times the automatic redial operation is performed when the recipient is
busy or does not answer.
Note • The default value varies by region. The default value is set when [Region] is set.
Redial Interval
Sets the amount of time the machine waits between redials.
You can set a value between 1 and 15 minutes (in 1 minute increments).
The time is set to [5 minutes] at the time of factory shipment.
Junk Filter
Used to set whether to block junk faxes from being received or not.
You can select [On] or [Off].
[Off] is set at the time of factory shipment.
To Next Page
Loading...
