130 4 Paper
When Tandem Tray is installed
This section describes how to load paper when Tandem Tray Module (optional) is installed.
Loading paper into Tray 3
1. Pull out Tray 3 until it stops.
2. Load the paper with its print side facing down
and its leading edge aligned with the left side
of the drawer.
Important
• Do not load paper of different types into the tray. Doing so
can cause paper jams.
• Do not load paper above the maximum fill line (the
position "MAX"). It may cause paper jams.
Loading paper into Tray 4
1. Pull out Tray 4 until it stops.
2. Load the paper with its print side facing down
and its leading edge aligned with the left side
of the drawer.
Important
• Do not load paper of different types into the tray. Doing so
can cause paper jams.
• Do not load paper above the maximum fill line (the
position "MAX"). It may cause paper jams.
To Next Page
Loading...
