A.7 Installing the TC/SC Additional Fonts Kit 383
A.7 Installing the TC/SC Additional Fonts Kit
This section describes how to install the TC/SC Additional Fonts Kit on the printer.
Installation Procedure
1. Press the printer's power switch to turn off the
power.
Note
• Make sure that there is no indication on the display, and
<Power Saver> button is off.
2. Open the front cover.
3. Press the < > side of the printer's main
power switch to turn off the main power and
close the front cover.
Note
• The <Main Power> lamp goes out on the control panel.
4. Unplug the power cord from the power outlet
and the printer.
TC/SC Additional Fonts Kit
To Next Page
Loading...
