5.2 Common Menus Setting 159
[DNS Server]
TransportProtocol Sets the protocol of the transport layer used by SNMP. Either or both of IPX and
UDP can be selected.
•[UDP] (default)
•[IPX]
•[IPX, UDP]
Note
• When using UDP protocol, both the printer and client computers must have IP
addresses.
• To determine which protocol (IPX or UDP) to use, refer to the manual supplied for
the application.
Network/Port
DNS Server
DNS Server
Server Settings
Server Settings
Get IP from DHCP
Server Settings
Server IP Address
Setting Description
Server
Settings
- Sets the DNS server settings.
Note
• When the Secondary Ethernet Kit (optional) is installed, [Server Settings 1] and
[Server Settings 2] are displayed.
Get IP
from
DHCP
Specifies whether or not to automatically acquire the DNS server IP address from the
DHCP server.
• [Enabled]
• [Disabled] (default)
Note
• Consult your network administrator for the IP address when setting it manually.
• When [Enabled] is changed to [Disabled], the screen for setting the IP address is
sometimes displayed. Manually set the IP address when this screen is displayed.
• When the IP address acquisition method is set to manual, this item is fixed under
[Disabled].
Server
IP
Address
These items allow you to verify the automatically acquired IP address or manually
enter the IP address. Enter the IP address in the format: xxx.xxx.xxx.xxx. For IP
addresses, xxx can be any number between 0 and 255. (See *2 on P. 215.)
Important
• Make sure that you set the IP addresses correctly. Setting the wrong addresses can
cause problems on the network.
Setting Description
To Next Page
Loading...
